Different Types Of Wrap Cable Grip
Wrap Cable Grips are essential tools for securing, pulling, or suspending cables in a wide range of industrial applications. Depending on the installation needs and cable types, various designs and structures are available to provide optimal support and ease of use. Below are different types of wrap cable grips, along with material details and installation instructions.
There are types of wrap cable grip.Like minitype rotate wrap cable grip,single mesh wrap cable grip,wrap feeder hanging net,double sides dragging wrap cable grip,single side dragging type and wrap cable grip,double sides dragging type and wrap cable grip.
Single Mesh Wrap Cable Grip Type Skt
It adopts a multi strand Steel Wire rope weaving, semi open type,which wraps the cable like a cloth and can be pulled at any part of the cable.
Wrap Feeder Hanging Net Type BDK
The materials of cable grip can be divided into hot-dip galvanized, stainless steel 304, and stainless steel 316. The material of the compression connection parts include aluminum alloy compression, stainless steel compression, and copper sleeve compression.
Double Sides Dragging Wrap Cable Grip Type STG
Double sides dragging, half open, Like a cloth cover the cable, can be dragged in any part on cable, easy installation,fixed,lifting,The material is made of stainless steel 316, Suppression copper set,with a condom ring, wear-resisting, corrosion resistant.Designed for overweight load submarine cable.
Single Side Dragging Type and Wrap Cable Grip SK
It adopts single strand soft wire weaving, with a soft mesh sleeve and unilateral traction.The product is a semi open type, wrapped in any part of the cable like a cloth, and a steel wire rope is threaded through the belt, which can be applied to any part of the cable.
Double Sides Dragging Type And Wrap Cable Grip MK
It adopts a single strand of steel wire weaving, with a soft mesh sleeve and double-sided traction.The product is a semi open type, and it is wrapped in the middle of the cable like a cloth for construction. A steel wire rope is threaded through the belt, which can be puled at any part of the cable.
The Installation Of the Double Sides Dragging Wrap Cable Grip
Please note: Check the condition of the cable grip before use. Correctly select cable grip that match the cable diameter and must not exceed the rated load. Do not use cable grip that are worn, bent, or damaged.
1.Select the appropriate size cable grip for the cable or wire.
2.Place the cable or wire into the mesh sleeve as shown in the diagram
3.Open the traction ropes on both sides thread the end of the left traction rope in to the first mesh on the left to the second mesh on the right, and thread the right traction rope into the second mesh on the left from the first mesh on the right.
4.At this stage, do not pull the traction rope too tightly and leave a space between adjacent rings, which is roughly equal to the width of a diamond in the grid.
5.The traction ropes on both sides continue to cross and thread out, and can be slowly tightened at this time.
6.Continue the above operations alternating left and right, tighten, and try to maintain the same tension and spacing as much as possible.
7.Finally, safely wrap the excess traction ropes at both ends together, tie them together, and cut off any excess.
8.At this point, the wrapped cable grip has been installed and can be used with confidence.
Each type of wrap cable grip offers unique advantages for specific cable handling scenarios, from lightweight single-mesh designs to heavy-duty dragging solutions. Proper selection and installation of the right cable grip not only enhance operational efficiency but also ensure safety and durability. Always follow the recommended guidelines for usage and inspection to achieve the best performance.